|
|
GROUP OF COMPANIES
IZOMETÒ Rapid Bonding Paste
HB0105 Bonding Agent For Concrete DATA SHEET
|
DESCRIPTION |
IZOMETÒ Rapid Bonding Paste is used for
repairing and/or strengthening work for determine good bonding. It could be used
in any place that needs well adhesion.
IZOMETÒ Rapid Bonding Paste is a two
component adhesive which is factory weighed an packaged so ready for site usage and is a blend of special
epoxy resins.
|
SPECIAL
FEATURES |
·
Good bond to concrete
·
Rapid Hardening
·
Non-shrink
·
Solvent-free
·
Excellent resistance to water and
most dilute chemicals
|
PHYSICAL PROPERTIES |
|
Property |
10°C |
20°C |
30°C |
|
Pot life |
4 hr |
2 hr |
1 ½ hr |
|
Initial hardness |
24 hr |
12 hr |
8 hr |
|
Full cure |
7 days at room |
temperature |
|
|
MECHANICAL PROPERTIES |
|
Compressive Strength |
Typical
Result |
|
After 12
hours at 20°C |
20 N/mm² |
|
After 1 day
at 20°C |
60 N/mm² |
|
After full
cure at 20°C |
80 N/mm² |
|
Flexural
strength at full cure |
20 N/mm² |
All tests made after full cure
|
INSTRUCTIONS
FOR USE |
·
SURFACE PREPARATION
Concrete or cement substrates
should be 28 days old and moisture content of substrate should be less than 5%
at least. All latience and loose materials must be removed from the concrete
surface. If needed use sand blasting to remove all dust, debris, oil or grease
from surface
·
APPLICATION
If possible mix all the components with a
mixer running at less than 400 rpm to avoid trapping air in material. Mix resin
and hardener until a uniform consistency is achieved.
Apply to both surfaces with stiff brushes
or rollers and press two sides together until resin hardened.
|
CURING |
Curing must be between 10°C - 30°C. Gets full cure after 7 days.
|
PACKING |
IZOMETÒ Rapid Bonding Paste is packed
(resin + hardener) in 1 kg boxes and one packs volume is approximately 0,75 lt.
|
STORAGE |
All materials should be kept in their tightly closed own packs. Under
these conditions shelf life is minimum 12 months at normal temperatures.
|
CAUTION |
Uncured epoxy resin kept away
from mouth, eyes, food or drink.
Empty tins must not be used
even cleaned by suitable methods.
During application or handling
uncured epoxy resins, wear gloves or barrier creams.
In case of contact with skin
immediately clean with warm water and soap.
Avoid inhaling vapor.
Do not use below 10°C and over 50°C.
No other materials should be
added.
|
SUPPLY |
IZOMAS GROUP OF COMPANIES
Headquarters
Cumhuriyet mah. Fatih cad. No:4
Kartal - Istanbul - TURKEY
Tel: +90 216 451 48 48 (PBX)
Fax: +90 216 309 74 57
http:\\www.izomas.com.tr
e-mail: izomas@izomas.com.tr
Izomet is a IZOMAS trade mark. This
material is manufactured in Turkey using raw material from and under the
supervision of Shell Chemicals. The information that given in this leaflet
is, prepared best of our current knowledge and given in good faith, but our
recommendations are made without guarantee because of the conditions of uses are beyond our
control. Buyers and applicators should prepare their own instructions for
their own conditions and requirements.